Leakage in plumbing systems is not only annoying, but it can also cause a lot of damage to your house.
It is very important to fix leaks immediately to stop the problem from becoming worse.
The first step to stopping a leak should be early detection.
If there is a persistent damp spot on the ceiling or on a wall, you know that you are facing a leakage problem.
However, it is not that easy to find out the precise location of the leak.
The water from a leaking pipe seeps through the inside of the wall before it becomes apparent on the outer surface.
In fact, it is quite common to find a damp patch on the wall even though the leak could actually be in the roof.
You will need to be aware of the plumbing system in your house, and using that knowledge you can try to guess where the leak is likely to be.
The shape of the damp patch should give you some clues on the source of the leak.
You should also remember that the most common cause of a leak is a joint between two pipes.
Once you have found the location of the leak, you should cut off the water supply to that area so that you can carry out repairs.
It should be easy to find a valve that can be turned off to cut off the water supply to a specific part of the house.
If the leak is due to a faulty joint, you can tighten the joint and check if that stops the leak.
To make sure that the leakage does not happen again, you can also apply epoxy putty around the joint.
However, if the plumbing system in your house is old, it would be better to replace the joint with a new one to avoid problems in future.
If the leak is in the body of a metal pipe, you can use a piece of rubber around it, and then use a steel clamp to hold the rubber in place.
The clamp should be tight enough so that no gap is left between the rubber and the pipe.
Although, these solutions will work for minor leaks, for any major problems, you would need the professional help of a plumbing company.
In most cases, a major leak necessitates replacing the pipe, and that is the job of an expert.