Pelican 7060 Directions
- 1). Charge the battery pack. The pack is only partially charged at the time of purchase and needs to be fully charged before use. Plug the transformer into the docking station and the station into the wall. Place the base of the Pelican 7060 into the docking station to charge.
The LED light display will indicate the following:
Red: The docking station is not connected to the Pelican 7060.
Flashing red: The Pelican 7060 is charging.
Green: The Pelican 7060 is fully charged. - 2). The Pelican 7060 is ready for use once it has been fully charged. Press down gently on the switch to turn the Pelican 7060 flashlight on for a moment. The switch should only be pushed down half way. As long as the switch is held in this position, the flashlight will shine. Release the switch to turn it off.
- 3). To switch the Pelican 7060 flashlight on permanently, press the switch hard until a 'click' sound is heard. Press on the switch hard again to turn it off.
