Installation Instructions for the Ati All in Wonder 128
- 1). Turn off the computer and unplug all wires from the back. Make a note of where your monitor plugs into. If it plugs in near the bottom, separated from the top connectors, then you will need to remove the existing graphics card.
- 2). Using a Philips screwdriver, unscrew the right side panel (when looking from the reverse). Slide the side off once you are done.
- 3). Unscrew the screw that holds in place the existing graphics card (if one exists at the bottom). Once it is unscrewed, remove the existing card.
- 4). Take your ATI Wonder 128 MB graphics card and push it into the graphics card slot. This is the top slot at the bottom-left of the motherboard. Attach the screw to secure the graphics card.
- 5). Reattach the side panels and wires at the back. Turn your computer on. If you did not remove an existing graphics card, then disable the onboard graphics in the BIOS. (Consult your motherboard documentation for how to do this.) If you did remove a graphics card, start up your system normally. Insert the installation disc and follow the onscreen instructions.
