IKEA Bead Instructions
- 1). Place a meltable bead peg board on a flat, uncluttered and clean surface.
- 2). Arrange Pyssla meltable beads onto the peg board so that the hole of each bead fits securely on one of the spikes on the board.
- 3). Carefully cover the beads and peg board with one sheet of wax paper so as to not disturb the design and knock the beads out of place on the peg board.
- 4). Turn the iron on and set at medium heat.
- 5). Iron over the wax paper gently for about 10seconds. The beads should fuse together as the plastic warms and melts. (See Reference 3)
- 6). Allow the beads to cool under the wax paper for about three minutes.
- 7). Carefully lift the design from the peg board.
- 8). Slowly peel the wax paper from the melted bead project.
